Juana Golden Harbor Freight January 03rd, 2020 - 02:25:40
The dimensions of the platform will depend upon the barrel you find. The barrel should ride on inverted casters mounted on the top of the platform. Position the casters so that the barrel will not jump off in either direction. If your barrel has beads where the top and bottom were attached, locate the casters just inside those beads. If your barrel is like mine, with a bead at the top and a taper at the bottom, the wheels should hit the barrel where it tapers at the bottom and just inside the bead at the top. Since there was no bead at the bottom, I attached a board between the wheels at what was the top of the barrel to keep the barrel from jumping off in that direction. The garden cart you plan to use will govern the height of your compost barrel's platform.
The next test involves cranking the car, and being safety aware (no hanging jewelry or long hair) and measuring voltage at the battery terminals. Read the voltage on the meter as someone else cranks the vehicle. The voltage should not drop below nine or ten volts. You may want to repeat this test to get an accurate reading. If the voltage is not within spec you should consider a new battery, or have your starter professionally tested.
Let's start with what I think is about the most important thing "protect that attitude". I know that isn't where most people start however without it cleaning that scoot will always be a headache. How do I protect it? First, get a motorcycle lift. They're not all that expensive these days. I got mine at Harbor Freight for about $300.00 and I can't tell you how much easier it is to clean any bike. You can get them much cheaper even as little as $60.00 or so. But my point is to get that baby up in the air so you don't have to hurt your knees, back or anything else. Nobody looks forward to kneeling or bending over for hours at a time. Do you think that might be a reason your friend's bikes may not be so clean?
So first thing you want to do to get started is to cut the flaps free at the top and the bottom of the box so the flaps remain intact. Find the seam where the machine glued the box together and cut along the crease originally made when the box was assembled. Don't bother trying to save the flap here as it usually tears the veneer from the corrugation.
Private Labels and Brands - Majority of the items being sold by Harbor Freight bear private label store brands or products that are produced by other manufacturers. The products usually have American Sounding brands but are actually made overseas. No need to worry though because the company offers a lifetime warranty for all the hand tools and equipment.
Purchase a simple multi-tester or multi-meter for less than ten dollars and perform the following test. With the car off, leave the headlights on for about 2-3 minutes. Set an alarm so you do not drain the battery, and turn the headlights off when it goes off. This will remove any surface charge. Set the multi-tester dial so it registers in the 20 Volt DC range. You can read the multi-tester instructions or research its use online. A multi-tester is very simple to use. Touch the red lead to the positive battery terminal, and the black one to the negative. A healthy, fully charged battery should read around 12.5-12.8 Volts. This will vary with temperature (lower temperatures mean lower voltage), but should never be below 12 Volts. Another optional suggestion is to touch the black multi-tester lead to your engine or a metal part of the vehicle. If the voltage is substantially lower you may have a bad cable connection.