Juana Golden Harbor Freight January 04th, 2020 - 01:14:54
Up to this point, all my work has been done with the oxyacetylene torch. And I can honestly say many works to come are going to be done by way of the torch. But I have always being curious about arc welding. Especially since the weld is instantaneous because of the 10000 degree heat. This is especially useful in projects that would take a considerable amount of time to complete with a torch such as building a welding table.
The fundamental secret to a successful fire is planning. Good fires do not just happen, they are made. What you will need to build the perfect fire is a chimney starter, fuel (hardwood, charcoal, or both), and either newspaper or lighter cubes. If you are using newspaper, crumple two full sheets and stuff into the bottom of the chimney starter. If you prefer lighter cubes (my personal preference) just place one under the chimney starter. Fill the chimney with fist-sized chunks of hardwood, or charcoal, then light the newspaper or lighter cube. When the wood chunks are glowing embers, or the charcoal is covered in gray ash, dump the chimney contents in the firebox.
Are you familiar with the trucks which are built simply to be a moving bill board? Do they work? They would not exist if they did not work! How can you get attention, and display a large sign while riding your motorcycle? Find out! So how are you going to get a big sign on your motorcycle? First, you need a hitch. Find one on eBay for about $200. Or, check with your local motorcycle mechanic. Get the hitch on, and you're ready to tow!
Each of the hand crank lead screws goes through an end plate that's bent from the leg support sheet metal. If you look closely, you'll notice that the lead screw plate is secured to the sidewalls by two sheet metal "ears" and two small dimples in the sidewalls. That looks like a potential source of failure downstream: nothing prevents the sidewalls from separating and allowing the crank to become loose. My fix? Simple: I installed a clamping and securing bolt through the sidewalls just behind the end plate. To secure the sideplates and preventing them from spreading apart, about 1 inch from the end plate, I drilled a ¼" clearance hole through the two sideplates (that also mount the legs) and put a 1 ½ inch long, ¼ -20 bolt with a washer and a locknut. Tightening the locknut makes the endplate securely clamped to the sidewall plates; this will prevent any tendency for that endplate holding the leadscrew and cranking handles from coming loose over time.
Second, "Time", I try to give myself all the time I need so as not to be rushed. This is extremely important. If you don't have enough time you will surely loose your focus, break a smooth routine and end with a bike half done. No doubt with an attitude that you wasted a great deal of time and you know your right you should have just jumped on that puppy and took off. Give yourself all the time you need and your whole world will turn easier. And when you do clean it your "good attitude" will go the distance. When you're done all that work will leave you with a sense that it wasn't so hard to do and doing it again won't be so bad. And don't forget to take breaks frequently, drink a little work a little, drink a little work a little you'll be amazed how quickly you get finished and how much better you'll feel.
We are concerned with the double face cardboard because of its availability. Occasionally building materials such as sheetrock mud, lacquer, and cement will splash onto the sheets of cardboard and dry while in the trash. Most substances will come off with a simple brush of the hand or with a stiff broom. You can remove more stubborn areas with a square nosed shovel, inverted so the underside of the scoop is up. This will prevent the shovel from digging into the corrugation.