Gladys Figueroa Harbor Freight December 11th, 2019 - 02:32:16
Table saw: 10 inch cabinet saw, not one of those little saws that set on a table top, Again find a second hand saw, 2 to 5 horse power and a simple fence is all you need. so long as the blade can be squared up and the fence can be adjusted true. rust can be overlooked, and belts can be replaced. One thing here to spend money on is the blade, carbide tipped 50 to 60 tooth spend $50.00 to $70.00. you will want two $50.00 blades not one $100.00 blade. One blade is either at the saw sharpener or ready to go the sharpener. point is a sharp lower cost blade is a lot better than dull $150.00 blade.
A brief word on charcoal. Briquettes are, by far, the most popular charcoal type. They light quickly and burn consistently. However, briquettes are made with additives, and those additives produce more ash. Lump charcoal (made by an oxygen deprived burning of hardwood) has no additives, produces less ash, burns much hotter than briquettes, and imparts a slight essence of the native wood to foods. But the biggest advantage of lump over briquettes is that lump can be added directly to the fire because all of the toxins have been burned out of the lump charcoal. Briquettes must be pre-burned; that means another chimney of coals before adding to the fire.
The grommet gives us a strong anchor point without worrying about any tearing or ripping or having nails or staples pull away from the wall from it's weight. A small round punch is used to make a perfect circle. I use a small scrap of plywood underneath the cutting operation so as not to dull the cutter. A steel base with 1/2 the grommet poking through the hole is placed below the cardboard. The other 1/2 of the grommet is placed on top of this with a steel punch made to curl the soft metal grommet in the base then smacked with a hammer till it seats down. Do not beat the piss out of it since the grommet since it crimps itself onto the cardboard. You would wind up with an even bigger hole that I'm not quite sure they make grommets for.
First off, lets cover some of my frugal basics of paint and painting supplies. Never throw away rollers unless you absolutely have to! Remember that most Halloween paints are black and grays, so washing out the color is near impossible. If enough paint is washed out the roller it becomes soft and fluffy and totally re-useable. It will still be black or gray but rinsing out enough paint to save some money isn't that much work.
Are you familiar with the trucks which are built simply to be a moving bill board? Do they work? They would not exist if they did not work! How can you get attention, and display a large sign while riding your motorcycle? Find out! So how are you going to get a big sign on your motorcycle? First, you need a hitch. Find one on eBay for about $200. Or, check with your local motorcycle mechanic. Get the hitch on, and you're ready to tow!
One plastic 50 gallon barrel. I located three on Craigslist and paid $24 for all three, so $8. Four three inch rigid-caster wheels. Harbor Freight has them for $3 each, so $12 for these. Treated wood, although I used 2X6's, treated deck wood would work just as well,$20. Paint for the barrel, $4.25. Paint for the platform,$7.50. Lag bolts and washers to mount the rigid casters $4.80. Two 2" PVC vent pipes cut from a ten foot length of pipe, $5. Four NIBCO 1 1/2 In. PVC DWV Trap Adapter Spigot x Slip Joints,$8. Window hardware: 8"continuous hinge and three cabinet latches, $9. The total is $78.55. Of course any of these materials you happen to have on hand will decrease your cost: